Instruction manual

Instruction manual for spiral mixer mod. CPM80-200

NOTE:

• the

• Only in phase 2 of the automatic cycle the button can be used with the

bowl stops its rotation for 2", then

it inverts the sense of rotation until the button is kept pressed. When released, the

" and it starts the anticlockwise rotation. The phase 2 timer

• The phase 1 starts with a delay in relation to the water dosing.

The 3 phases are carried out in sequence with a fixed 3 second delay between

first and second phase in order to obtain the complete stop of the bowl before the

inversion.

following function: while it is kept pressed, the

bowl stops again for 2

continues the timing regularly and the spiral always rotates.

• Phase 3 follows immediately phase 2.

MANUAL CYCLE:

• also in the manual phase by selecting

the button : the figure “MA” will appear on the program display and all the

to flash. Pressing the start button the

splay counting the time. Pressing stop the

phase stops and the time remains fixed on

once again the timing goes to zero.

• ass directly

• With the machine stopped it is possible to start from any phase, but in phase 3 it is

ng to

• The machine can be stopped pressing the button

• n manual mode the doser works seperately in relation to the mixers functions.

To go back to the automatic cycles, press again the button .

NOTE:

With the protection grid open the machine stops immediately. Only the following

functions remain active :

• Rotation of the bowl with the two buttons

• Doser in manual position

All the phases described can be performed

other displays will be at zero. To select the phases it is sufficient to press the

corresponding button and the display starts

corresponding phase start with the di

the display. Pressing the stop button

• If the button 2 and 3 are pressed during phase 1, nothing happens.

Viceversa it is possible to press the button while in phase 2 and p

in phase 3.

not possible to start directly: the machine does 5” in phase 2 before passi

phase 3

NOTE:

When any of the protections are open , the cycle does not start automatically again,

but it is necessary to press start.