Users Manual Part 2

5. Insert a fully charged pump battery into the
pump's battery bay.
The pump will be in pairing mode and sound a
ready tone (one beep). If you hear a different
tone,
See "Troubleshooting Pump" on
page189.
6. Locate your pump’s serial number on the
bottom of the pump.
7. Place the pump and remote within 2 in (50
mm) of each other during the pairing process.
8. If your pump's serial number does not show up
on screen after a minute, press and hold the
pump’s blue button for 10 seconds to
activate pairing mode. Then, check the screen
again for your pump serial number.
Set Up
54 DKPI-09153-001-Rev. 1.4