Users Manual Part 2

Charge the Pump Batteries
You must charge the Pump Batteries before you
can use the pump. A fully charged pump battery
can power the pump for 3 days (72 hours).
Each time you replace a cassette, you should also
replace the pump battery with a fully charged
battery.
You can charge up to two pump batteries using the
battery charger, and one pump battery using the
remote. See "Charge the Remote and One Pump
Battery" on page48.
The pump battery charger may be connected to
any USB port for battery charging.
Charging the pump batteries using the dual USB
AC Adapter will take about 6 hours. Charging the
pump batteries using only the USB Cable (e.g.,
through a personal computer) may take more time.
If the pump batteries have been subjected to the
extremes of the specified storage temperatures,
before charging or using the batteries allow them to
cool off / warm up for 20 minutes.
1. Plug in one of the USB cables into the battery
charger and the other end of the USB cable
into the dual USB wall adapter.
2. Then plug the dual USB wall adapter into an
AC power outlet.
Set Up
46 DKPI-09153-001-Rev. 1.4