Owner`s manual

10
30SB,36SB,45SB

Rev Nov2014
Snow BEAST
1.Locatetheconnecon:Thechuterotaoncableconneconislocatedat
thebaseofthedischargechutebetweentheengineandthedischargechute.
2.Slidethethreadedendoftheconnectordown
thecableinordertoeasilyseetheendofthecable
connecon.Thecenterseconshouldbeabout
3/4”to1”beyondtheendofthecable.
NOTE:Thereisnothingwrongiftheendofthecen‐
terseconofthecableprotrudesmorethanabout
3/4”to1”beyondtheendofthecable.
Thecenterseconcanbeeasilypushedbackinto
thecable.
3.Alignthecenterseconwiththecablechutero tator.Theend
ofthecenterseconissquareandrequiresproperalignmentin
ordertocorrectlyconnecttothemachine.
4.Pressthecabletowardthechuterotatorscrew .Theendof
thecableshouldtouch theendofthechuterotator.
Ifthesurfacesdonot
contact,connuetoapplypressureand
slowlyrotatethedischargechutedireconhandleonthecontrol
panelsothecenterofthecablealignsitselfonbothends.
5.SlidethethreadedendfromStep2towardthechuterotator,
andthreadtheendontothechuterotator.
IMPORTANT:
Fingerghtenfirmly.Inspectbeforeeachusetomakecertain
theconnecondoesn’tloosenduringoperaonofthemachine.
Step 3: Chute Rotaon Cable (connued)
Assembly Instrucons
Need Help With Assembly?
(919)‐550‐3221