Owner`s manual

9
30SB,36SB,45SB

Rev Nov2014
Snow BEAST
Assembly Instrucons
Step 1: Control Panel Handles

1. Alignthetwoholesoneachsideofthecontrolpanel
handlesoverthelowerhandleframe.

2. Inserttheboltsthroughthehandlebarholesandframe
holes.Secureinplacewithhardwareprovided.Insert
boltsfromtheinside.
Step 3: Chute Rotaon Cable
Aachthecablecomingfromthemiddleofthe
controlpanelbyscrewing thecableendontothe
cranksecon.
Seenextpageforspecificinstruconsregarding
thisassembly.

Need Help With Assembly?
1‐919‐550‐3221
Step 2: Direconal Discharge Chute
1. Fittheblackplascroundspacerontoimpeller
housingbeforeinstallingchute.Applylightcoatof
greaseontospacer. 
2. Installtheboltsfortheretainerbracketswiththe
plascspacerbetweenthechuteandthesteel
retainingtabs.

DONOTOVERTIGHTEN.Ifthebracketis
tooghtthe
chutewillnotmoveproperly.Ensurethereisenough
spacebetweentheimpellerhousingandthebracketonall
sidessothat thechuterotatessmoothly.