Owner`s manual

54Z, 62Z

Z- BEAST

BEAST Finish Mower

Rev: Mar2011

Step 6: Brake Operation

Step 7: Wire Harness Assembly and Connections

The pre-wired handle bar assembly has a total of four (4)

connections. Route the wire harness as shown in the top right

photo and make the following connections indentified by

number in the other photos:

1. Route the smaller, white, 2-pin connector through a hole

in the chassis and connect it to the blade activation

safety switch 2-pin connector.

2. Connect the larger, 5-pin connector to the mating

connector at the rear of the engine.

3. Connect the black wire to a ground lug located on the

back or side of the engine.

4. If equipped, attach the yellow wire to the bottom of the

starter motor solenoid on the engine, with the positive

(red) battery cable.

Attach the positive (red) and ground (black) battery terminal

wires to the battery to provide power to the electric starter.

Note: Battery ground should be to the engine block.

Once all connections are made, use the provided black wire-

ties to strap the wire harness into place permanently to the

handle bars and chassis.