Owner`s manual

54Z, 62Z

Z- BEAST

BEAST Finish Mower

Rev: Mar2011

Step 4: Connecting Battery

1. Unwrap the protective tape off the positive wire and

attach it to the mower’s positive battery terminal on

the left side of the mower. When attached to the

terminal screw in the wire to keep it in place.

2. Unwrap the tape off the negative wire and ground it to

the right side of the mower. Repeat process

mentioned above to attach the ground wire.

Attaching Positive Wire

Connect screws through proper holes

on bottom of rollbar

DANGER

DANGER: Battery electrolyte has sulfuric acid which

can cause severe burns and is also deadly poison.

Never drink and always avoid contact by wearing gloves

and safety glasses when servicing the battery.

WARNING

WARNING!

There is no rollover protection while the roll bar is not

locked in its fully raised position.

 Never lower the roll bar while mowing.

 Always use seat belt when the roll bar is in its raised

position.

 If conditions require the roll bar to be lowered, do not

use the seatbelt.

Step 5: Connecting Rollover Protection System.

1. Connect the screws through the proper holes on the

bottom of the rollover protection bar to the holes on the

mower and tighten.

2. Do the same with the opposite side

3. Attach the top part of the rollover bar to the middle part

just locked into place using the same method on

both the left and right side.

4. Next place the pins into the upper hole on the top bar and

lock them to keep the roll bar locked in the upright position.

Attaching middle part

Putting pins in holes

Attaching Negative Wire