Owner`s manual

54Z, 62Z

Z- BEAST

BEAST Finish Mower

Rev: Mar2011

Assembly Instructions

Step 2: Rear Wheel Assembly

Note: Some mowers may be shipped with the rear wheels

pre-assembled.

A. Remove packaging materials surrounding the rear wheels

and remove the bolt threaded into the rear wheel. Retain

this bolt and washer for future use.

B. Jack up the mower from the rear center.

C. Transfer the weight from the jack to the jack stands, using

one jack stand on each rear axle.

D. Make sure that the wheels are facing the correct position

before securing. The V-shape on the tires should be

facing forward and the valve stem facing out.

E. When securing the tires make sure to secure the opposite

nut from the one secured first similar to securing a car’s

tires.

F. Repeat steps A through E for the second rear wheel.

G. Apply grease to the rear wheel sleeve grease fittings

when complete.

Step 3: Mower Handles Assembly Instructions

A. Attach handle bars to the suitable position for the operator

by making sure that the handles are at a comfortable

neutral position. The neutral position can be identified by

finding the position of the bars that is capable of being

pushed apart.

B. When adjusting the position of the handle bars be certain

that the handle bars can not go further than the operator’s

arm length.

C. The handle bars must also be able to be pulled back to its

entirety for safety purposes.

D. When handle bars are in the position best suited for the

operator, properly secure the bolts that attach the handle

bars to the mower.