Daim Ntawv Qhia Tus Neeg Siv

quick setup guide

pure water dispenser

SERIES

Read all directions before plugging

in dispenser.

IMPORTANT: Do not plug in dispenser until step 5.

This guide is a general reference to help you quickly

and easily set up your Pure Water Dispenser

300

Series. For complete setup, operating and safety

instructions, reference the owner’s manual.

Plug in dispenser to a GFCI outlet.

Purge water tanks.

Place cup under HOT dispenser

nozzle, lift red lever and pull out

handle until HOT tank is full and

one cup of water has been

dispensed. Repeat this step for

the COLD water tank.

Turn on heater switch.

Turn on hot tank heater using

switch located on rear of

dispenser. Water will become

hot in approximately 1 hour.

Red light will go off when hot

tank reaches operating

temperature.

To learn more, visit water.com

Place dispenser on level floor

surface at least 2 inches from wall.

Insert bottle and fill dispenser with

water PRIOR to plugging in.

Remove tamper-evident seal from plastic bottle

cap. (Do NOT remove plastic cap if using a

NO-SPILL water bottle.) Load water bottle by

lifting and inserting it onto probe. Be sure bottle

is fully aligned with dispenser, centered over

probe and fingers or other body parts are clear

of underside of bottle. Apply slight pressure until

plug pushes in and bottle is securely seated.

Water will flow into the tank causing air bubbles.