Daim Ntawv Qhia Tus Neeg Siv

SERIES

quick setup guide

pure water dispenser

Read all directions before plugging

in dispenser.

IMPORTANT: Do not plug in dispenser until step 5.

This guide is a general reference to help you quickly

and easily set up your Pure Water Dispenser

100

Series. For complete setup, operating and safety

instructions, reference the owner’s manual.

Plug in dispenser to a

GFCI outlet and turn on.

Turn on hot tank heater using

switch located on rear of

dispenser. Water will become hot

in approximately 1 hour. Red light

will go off when hot tank reaches

operating temperature.

Dispense water.

Place a cup under hot and

cold faucets and depress each

handle until water flows

continuously.

Insert drip tray.

Drip tray snaps into place

as shown.

To learn more, visit water.com

Place dispenser on level floor

surface at least 2 inches from wall.

Insert bottle and fill dispenser with

water PRIOR to plugging in.

Remove tamper-evident seal from plastic bottle

cap. (Do NOT remove plastic cap if using a

NO-SPILL water bottle.) Load water bottle by lifting

and inserting it onto probe. Be sure bottle is fully

aligned with dispenser, centered over probe and

fingers or other body parts are clear of underside

of bottle. Apply slight pressure until plug pushes in

and bottle is securely seated. Water will flow into

the tank causing air bubbles.