Installation guide

16
©
2001
Directed Electronics, Inc.
Menu #2 - Advanced Features
Feature Descriptions
The features of the system are described below. Features that have additional settings that can be
selected only when programming with the PC interface or Bitwriter are indicated by the following
icon:
Menu #1 - Basic Features
1-1 ACTIVE/PASSIVE ARMING: When active arming is selected, the system will only arm when
the transmitter is used. When set to passive, the system will arm automatically 30 seconds after the
last door is closed. To alert the consumer of passive arming, the siren will chirp 20 seconds after the
door is closed. This provides the consumer with an audible warning prior to the system actually
arming. At the 30 second mark, the system will arm but the siren will not chirp.
1-2 CHIRPS ON/OFF: This feature controls the chirps that confirm the arming and disarming.
1-3 IGNITION CONTROLLED DOOR LOCKS ON/OFF: When turned on, the doors will
lock three seconds after the ignition is turned on and unlock when the ignition is turned off.
The TechSoft Programmer (P/N 996T) or the Bitwriter (P/N 998T) will display separate steps for
ignition lock and ignition unlock. They can be programmed on or off independently.
1-4 ACTIVE/PASSIVE LOCKING: If passive arming is selected in step 1-1, then the system can be
programmed to either lock the doors when passive arming occurs, or only lock the doors when the
Feature One Chirp Two-Chirp
Number Setting (Default) Setting
2-1 Siren Horn honk
2-2 30-second siren duration 60-second siren duration
2-3 False Alarm Control Technology ON False Alarm Control Technology OFF
2-4 Progressive door trigger Instant door trigger
2-5 Valet switch input: 1 pulse Valet switch input: 2-5 pulses
2-6 Door trigger error chirp ON Door trigger error chirp OFF
2-7 Ignition-controlled domelight ON Ignition-controlled domelight OFF
2-8 Single unlock pulse Double unlock pulse
2-9 Channel 3: Validity Channel 3: latched/latched, reset
with ignition/30-second timed/
second unlock output