Installation guide

14
©
2001
Directed Electronics, Inc.
you wish to access, release the button and go on to Step 4. If the button is not
released, you will jump to the Advanced Features Menu #2 and the siren will
chirp twice. Once you have selected the desired menu, release the
Valet/Program button and then proceed to Step 4.
4. Select a Feature. Press and release the Valet/Program switch the number of
times corresponding to the feature you wish to change. For example, to access
the third feature, press and release the switch three times. Then press the switch
once more and HOLD it. The siren will chirp the number of times equal to
the step you have accessed.
5. Program the Feature. While HOLDING the Valet/Program switch, you can
toggle the feature on and off using the remote transmitter. Pressing
will select the one chirp setting. Pressing will select the two chirp setting.
(See the System Features Menus section of this guide.)
NOTE: The Valet pulse count feature (2-5) and the Channel three timed
output (2-9) have five possible settings each. Pressing will toggle through
all the possible settings.
6. Release the Valet/Program switch.
Once a feature is programmed:
➤➤
Other features can be programmed within the same menu.
➤➤
Another menu can be selected.
➤➤
The learn routine can be exited if programming is complete.
To access another feature in the same menu:
1. Press and release the Valet/Program switch the number of times necessary to advance from the
feature you just programmed to the next one you want to program.
2. Then press the Valet/Program switch once more and HOLD it.
For example, if you just programmed the third feature in the menu and you would like to program
the seventh feature in the menu, you would press and release the Valet/Program switch four times
and then press it once more and HOLD it. The siren would chirp seven times to confirm access to
the seventh feature.