Installation guide

4
©
2001
Directed Electronics, Inc.
What Is Included
The following components are included with this installation kit:
Warning! Safety First
The following safety warnings must be observed at all times:
➤➤
Due to the complexity of this system, installation of this product must only be performed by an
authorized Directed dealer.
➤➤
When properly installed, this system can start the vehicle via a command signal from the remote
control transmitter. Therefore, never operate the system in an area that does not have adequate
ventilation. The following precautions are the sole responsibility of the user; however, authorized
Directed dealers should make the following recommendations to all users of this system:
1. Never operate the system in an enclosed or partially enclosed area without ventilation (such
as a garage).
2. When parking in an enclosed or partially enclosed area or when having the vehicle serviced,
the remote engine starting system must be disabled using the installed toggle switch.
3. It is the user's sole responsibility to properly handle and keep out of reach from children all
remote transmitters to assure that the system does not unintentionally remote start the vehicle.
4. THE USER MUST INSTALL A CARBON MONOXIDE DETECTOR IN OR ABOUT THE
LIVING AREA ADJACENT TO THE VEHICLE. ALL DOORS LEADING FROM
ADJACENT LIVING AREAS TO THE ENCLOSED OR PARTIALLY ENCLOSED
VEHICLE STORAGE AREA MUST AT ALL TIMES REMAIN CLOSED.
➤➤
One control module
➤➤
One XHF receiver/antenna
➤➤
Two four-button remote transmitters
➤➤
One 514C siren
➤➤
One plug-in LED indicator with bezel
➤➤
The plug-in Valet/program switch
➤➤
One plug-in shock sensor
➤➤
A hood pinswitch
➤➤
A toggle override switch
➤➤
One 5-pin harness with relay satellite
➤➤
12-Pin, 11-wire primary harness (H1)
➤➤
3-Pin auxiliary harness (H2)
➤➤
3-Pin door lock harness (H4)
➤➤
6-Pin remote start harness (H3)
➤➤
One warning label
➤➤
Two window decals
➤➤
One patent card
➤➤
One warranty registration
➤➤
One installation guide
➤➤
One owner’s guide