Installation guide

False Alarm Control Technology (FACT)
FACT requires that you change the way you test the system as FACT will bypass an input zone for
60 minutes. If the system “sees” the same zone trigger three times AND the triggers are spaced less
than an hour apart, the system will bypass that input zone for 60 minutes. If that zone does not
attempt to trigger the system during the 60-minute bypass period, the zones monitoring will begin
again at the end of the hour. If it does attempt to trigger while bypassed, the 60-minute bypass starts
over again.
Disarming and rearming the system does not reset FACT. The only way to reset FACT is for the 60
minutes to pass, without a trigger, or for the ignition to be turned on. This allows the system to be
repeatedly triggered, disarmed and rearmed, and still allow FACT to bypass a faulty zone.
When disarming the system, 5 chirps indicate FACT is activated. The LED will report the zone that
has been bypassed. (See the Table of Zones section of this guide.)
Valet Mode
To enter or exit Valet Mode with the Valet/Program switch:
1. Turn the ignition on and then off.
2. Within 10 seconds, press and release the Valet/Program switch. The LED
status indicator will light solid if you have entered Valet Mode, and will go out
if you have exited Valet Mode.
To enter or exit Valet Mode with the transmitter:
1. Open any door.
2. Press on the transmitter.
3. Press .
4. Press again. You have now entered or exited Valet Mode (verify by checking the LED
status indicator).
www.clifford.com
39