Installation guide

the system is armed via the transmitter. Active locking means the system will not lock the doors

when it passively arms. Passive locking means that the system will lock the doors when it passively arms.

NOTE: Remember, when passive arming is selected, the unit will chirp 20 seconds after the last

door is closed. The system does not actually arm or lock the doors until 30 seconds after the door

has been closed.

1-5 PANIC WITH IGNITION ON: This feature controls whether or not the panic mode is

available with the ignition on. In some states, there are laws prohibiting a siren sounding in a

moving vehicle. This feature makes the system compliant with these regulations.

1-6 DOOR LOCK PULSE DURATlON: Some European vehicles, such as Mercedes-Benz and Audi,

require longer lock and unlock pulses to operate the vacuum pump. Programming the system to

provide 3.5 second pulses, will accommodate the door lock interface in these vehicles. The default

setting is 0.8 second door lock pulses. Some modification to the door lock harness (H4) is also

necessary. (Refer to Type E Door Locks - Mercedes-Benz and Audi -1985 and Newer, in the Door Lock

Wiring Guide provided on www. directechs.com or through DirectFax 1-800-999-1FAX.)

1-7 FORCED PASSIVE ARMING ON/OFF: To use this feature, passive arming must be selected in

Feature 1-1. When turned on, forced passive arming will ensure that the system will passively arm, even

if a zone is left open or invalid. Forced passive arming occurs one hour after the ignition is turned off.

1-8 AUTOMATIC ENGINE DISABLE (AED) ON/OFF: AED is a full-time, passive starter disable

that works independently of the security system. When turned on, the orange, ground-when-armed

output (H1/1) will activate 30 seconds after the ignition is turned off. The LED will flash at half its

normal rate when the ignition is turned off to indicate that AED is active and will interrupt the

starter in 30 seconds. AED does not occur in Valet mode and can be bypassed using the emergency

override procedure. The transmitter can be used to disarm AED, however, the system must be

armed and then disarmed, using the transmitter, to disarm AED.

1-9 ARMED WHILE DRIVING (AWD) ON/OFF: In the default setting (Armed While Driving),

the system can be armed with the ignition on. When armed, the ground-when-armed is not active

and the sensors are bypassed. The door triggers will remain active.

1-10 ANTI-CODE GRABBING ON/OFF: The system uses a mathematical formula to change its

code each time the transmitter and receiver communicate. This makes the group of bits or “word”

from the transmitter very long. The longer the word is, the easier it is to block its transmission to

the unit. Disabling this feature lets the receiver ignore the Anti-Code Grabbing part of the trans-

mitted word. As a result, the unit may have better range with the Anti-Code Grabbing feature off.