Installation guide

www.clifford.com 17
H3/2 BLUE/BLACK (-) Optional Third Ignition Output
This output provides a 200mA output as soon as the remote engine starting system is activated. It
can be used to power a relay to energize a positive (+) third ignition as shown below. This output is
capable of driving two relays if necessary.
H3/3 GRAY (-) Hood Pinswitch Input, Zone 1
This wire MUST be connected to hood pinswitch. This input will disable or shut down the remote
engine starting system when the hood is opened. It will also trigger the security system if the hood
is opened while the system is armed and report Zone 1.
H3/4 BROWN (+) Brake Switch Input, Zone 1
This wire MUST be connected to the vehicle's brake light wire. This is the wire that shows (+) 12V
when the brake pedal is depressed. The remote engine starting system will be disabled or shut down
any time the brake pedal is depressed. This wire will also trigger the security system if the brake
pedal is pressed while the system is armed and will report Zone 1.
H3/5 VIOLET/WHITE Tachometer Input
This input provides the module with information about the engine's revolutions per minute
(RPMs). It can be connected to the negative side of the coil in vehicles with conventional coils. In
multi-coil and high energy ignition systems locating a proper signal may be more difficult. Once