Installation guide

2001

Directed Electronics, Inc.

Remote Start Ribbon Plug-In Harness

___

Remote Start Harness (H3) Wire

Connection Guide

___

H3/1 BLUE (-) Status/Factory Security Rearm Output

This wire supplies a 200mA output as soon as the module begins the remote engine starting process.

It can be used with a relay to disconnect a sensor from the system as shown below. The H3/1 BLUE

wire can also be used to rearm a factory anti-theft system when the remote engine starting system

shuts down. (See the Feature Descriptions section of this guide.) To bypass an optional sensor:

BLACK/WHITE (-) Neutral Safety Switch Input

VIOLET/WHITE Tachometer Input Wire

BROWN (+) Brake Switch Shutdown Wire

GRAY (-) Hood Pinswitch Input, Zone 1

BLUE/BLACK (-) 200 mA Optional Third Ignition Output

BLUE (-) 200 mA Status/Factory Security Rearm Output

H3/1

H3/2

H3/3

H3/4

H3/5

H3/6

PURPLE (-) 200 mA Starter Relay Turn-On

ORANGE (-) 200 mA Accessory Relay Turn-On

PINK (-) 200 mA Ignition Relay Turn-On

YELLOW (+) Ignition Input to Remote Start

RED (+) Constant Power