Installation guide

www.clifford.com

Relay Satellite Key Switch Interface Wire

Connection Guide (Heavy Gauge Wires)

The five heavy gauge wires coming from the relay satellite are used to energize high current circuits

in the vehicle. It is crucial that these connections are well-made and capable of handling the current

demands. For this reason, Scotch-Locks, T-taps and other such connectors are strongly discouraged.

___

RED (2) (+) 12V Input for Relays

Remove the two 30-amp fuses prior to connecting these wires and do not replace them until the

satellite has been plugged into the control module. These wires are the source of current for all the

circuits the relay satellite will energize. They must be connected to a high current source. Since the

factory supplies (+)12V to the key switch that is used to operate the motor, it is recommended that

these wires be connected there.

NOTE: If the factory supplies two separate (+) 12V feeds to the ignition switch, connect one RED

wire of the satellite to each feed at the switch.

PINK (+) Ignition Output

Connect this wire to the ignition wire in the vehicle.

ORANGE (+) Accessory Output

Connect this wire to the accessory wire in the vehicle that powers the climate control system.

PURPLE (+) Starter Output

Connect this wire to the starter wire in the vehicle.

PINK/WHITE (+) Output to Second Ignition Circuit

Connect this wire to the second ignition wire in the vehicle.

NOTE: For vehicles that do not have a second ignition wire, this connection is not required.

PINK/WHITE (+) Output to Second Ignition Circuit

PURPLE (+) Output to Starter Circuit

ORANGE (+) Output to Accessory Circuit

PINK (+) Output to Ignition Circuit

RED (+) High Current 12V Input