Installation guide

transmitter configurations

The transmitters can be programmed with the separate or single button arm/disarm configurations by using the

Auto-learn functions in the Transmitter/Receiver Learn Routine.

When programmed for single button arm/disarm configuration using the Channel 7 Auto-learn configuration, the

transmitter buttons are assigned to the following functions:

.....................................operates...........................Arm/Disarm/Panic

....................................operates...........................Channel 2

and .....................operates...........................Remote Start

To configure the system's remote transmitters for Separate Button Configuration, an optional four-button trans-

mitter must be used. A remote that uses the separate button configuration operates similarly to many factory

keyless entry remotes. A separate button configuration transmitter allows arming, disarming, and Panic Mode

activation with separate buttons. When programmed for separate button configuration using the Channel 8 Auto-

learn configuration, this is an example of how a four-button transmitter’s functions might be assigned:

.....................................operates...........................Arm only

...................................operates...........................Disarm only

..................................operates...........................Channel 2

...................................operates...........................Panic only

and ......................operate............................Remote Start

separate button configuration

single button arm/disarm configuration