Installation guide

This wire sends a negative pulse every time the remote start is activated. This can be used to pulse the disarm

wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the disarm wire as shown

in the diagrams below. This wire can also be used as a special accessory output. (See Feature Descriptions section

of this guide.)

Relay for Negative (-) Disarm Wire Relay for Positive (+) Disarm Wire

remote start harness (H3) wire connection guide

This wire supplies a 200mA output as soon as the module begins the remote start process. The H3/1 BLUE wire

can also be used to rearm a factory anti-theft system when the remote start shuts down. (See the Feature

Descriptions section in this guide for details about programming this output.)

This output provides 200mA as soon as the remote starter is activated. It can be used to power a relay to ener-

gize a positive (+) third ignition as shown below. This output is capable of driving two relays if necessary.

H3/2 BLUE/BLACK (-) optional third ignition output

H3/1 BLUE status/factory security rearm output

H2/2 LIGHT GREEN/BLACK (-) auxiliary output