User Guide

transmitter/receiver learn routine

The system comes with two transmitters that have been taught to the receiver. Use the following learn routine

to add transmitters to the system or to change button assignments if desired.

The Valet/Program button, plugged into the blue port, is used for programming. There is a basic sequence to

remember whenever programming this unit: Door, Key, Choose, Transmit and Release.

1. Open a door. (The GREEN wire, H1/5, or the VIOLET, H1/7 must be connected.)

2. Key. Turn the ignition on. (The H1/9 YELLOW switched ignition input must be connected.)

3. Select the receiver channel. Press and release the Valet/Program switch the number of

times necessary to access the desired channel. Once you have selected a channel, press

and HOLD the Valet/Program switch once more. The siren will chirp and the LED will blink

the number of times corresponding to the channel that has been accessed.

NOTE: If adding a remote, a button must be taught to Channel One prior to programming other

channels.

NOTE: If any transmitter button from a known transmitter is programmed to Channel Five, all trans-

mitters will be erased from memory. This is useful in cases when one of the customer's transmitters

is lost or stolen. This will erase any lost or stolen transmitters from the system's memory. It can

also be used to start from scratch if the transmitter buttons were programmed incorrectly.

CHANNEL PRESS AND RELEASE

NUMBER THE VALET/PROGRAM SWITCH TO PROGRAM FUNCTION

1 One Time Arm/Disarm/Panic

2 Two Times Channel 2

3 Three Times Channel 3

4 Four Times Auto Learn Standard Configuration*

5 Five Times Delete all transmitters

*NOTE: For Auto Learn Standard Configuration, see Transmitter Configuration section

of this guide.