Specifications

12
2.6 Assembl
y
of Elevation-Motor
(
EMO
)
1st step:
Fix Elevation motor (EMO) (Pos.
4) at the base frame (Pos. 3) by
using bolt M14x70 (Pos. 5), nut
M14 (Pos. 6) and washer M14
(Pos. 7). Attention needs to be
paid to the bore holes for
dewatering. They need to be on
the lower side.
2nd step:
Fix Elevation motor at the rotation head (Pos.2) by using
the spezial screws M12x50 (Pos.8). Therefore the
enclosed thread locking fluid (Pos. 14) has to be used.
Tighten the special screws with a tarquet of 35 Nm.
- Do not use any other screws except those
included in the delivery (Pos.8)!
- Apply max. one drop of the locking fluid to the
internal thread of the EMO.
- Ensure that no locking fluid enters into the
sliding bearing connector!
The EMO is delivered with preseted limit switches so no
set up work has to be done at all.
Warning!!
The enclosed BEST-MK 1325 thread locking fluid must be used!!
Checking of the elevation- and east-west-mechanics
Extend and retract the complete way of the drive, to guarantee that the mechanics moves freely,
doesn't knock agaist anything and that the cables are long enoungh. Use a 12V or 24V batterie
(for ex. suitable for a battery-driven drill) for the head of the drive.
Pos.4
Pos.2
Pos.5
M14x70
Pos.6
Pos.4
Pos.8
M12x50
Pos.8
M12x50
Pos.3