Specifications

Alarm 1. The hour digits on the LCD panel will flash.

2. Rotate the “TUNE” knob (15) to adjust the hour, then press the “M/F” button

(20) again, the minute digits on the LCD panel will flash.

3. Rotate the “TUNE” knob (15) to adjust the minute, then press the “M/F”

button (20) again, the station presets will flash.

4. Rotate the “TUNE” knob (15) to select the station preset, then press the

“M/F” button (20) again, the volume level will flash.

5. Rotate the “TUNE” knob (15) to select the then press the “M/F” button (20)

again.

6. Select the duration of Alarm 1 (from 5 to 99 minutes).

7. Finally, press the “M/F” button (20) to confirm. The “Alarm 1” sign will be

displayed on the LCD panel, indicating that Alarm 1 is activated, the radio

will turn on/off according to the particulars of the Alarm 1 settings.

NOTE: When setting the Alarm, if there is no change in the default settings,

you can just press the “M/F” button (20) or the “STORE” (19) button to skip for

faster operation.

SETTING ALARM 2

1. Turn off the radio, press the “STORE” button (19) for 3 seconds to enable

Alarm 1. The hour digits on the LCD panel will flash.

2. Following the similar procedures for setting the Alarm 1 except that the

“M/F” button should be changed to the “STORE” button (19). When these

steps are finished, the “Alarm 1” sign will be displayed on the LCD panel,

indicating that Alarm 2 is activated, the radio will turn on/off according to the

particulars of the Alarm 2 settings.

 If there are conflicts in the two alarm settings, the alarm settings with the

later time will replace the alarm settings of an earlier time.

 The settings of alarm(s) is/are always valid unless the alarm(s) is/are

deactivated.

DEACTIVATING THE ALARMS

Deactivating Alarm 1

Turn off the radio, press “M/F” button (20) once, the “Alarm 1” sign will