DAW 321 YOU CAN RELY ON DEFY 850 www.defy.co.
Safety instructions 1 Warnings General Safety • Never place your machine on a carpet covered floor. Otherwise, lack of airflow from below of your machine may cause electrical parts to overheat. This may cause problems with your washing machine. • If the power cable or mains plug is damaged you must call Authorized Service for repair. • Fit the drain hose into the discharge housing securely to prevent any water leakage and to allow machine to take in and discharge water as required.
2 Installation Removing packaging reinforcement Tilt the machine to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon. Opening the transportation locks A Transportation safety bolts must be removed before operating the washing machine! Otherwise, the machine will be damaged! 1. Loosen all the bolts with a spanner until they rotate freely (“C”) 2. Remove transportation safety bolts by turning them gently. 3.
Detergents and softeners • The maximum length of the combined hoses must not be longer than 3.2 m. Electrical connection Connect the machine to an earthed outlet protected by a fuse of suitable capacity. Important: • Connection should comply with national regulations. • The voltage and the allowed fuse protection are specified in the section “Technical Specifications”. • The specified voltage must be equal to your mains voltage. • Connection via extension cords or multiplugs should not be made.
4 Selecting a Program and Operating Your Machine Control panel Figure 1 1 7 6 3 Synthetics Intensive + ECO 40 Woollen Start / Pause Time Delay Hand Wash Cancel 3 sec.
• Cotton You can wash your durable clothes with this program. Your laundry will be washed with vigorous washing movements during a longer washing cycle. • Synthetics You can wash your less durable clothes on this program. Lighter washing movements and shorter washing cycle is used compared to “Cottons” program. It is recommended for your synthetic clothes (such as shirts, blouses, synthetic/cotton blended garments, etc.).
- Adjust the spin speed. Press “Start/Pause/Cancel” button. Program resumes. Your machine drains the water and spins your laundry. You can use no spin function in order to drain the water without spinning at the end of the program. Program selection and consumption table EN Auxiliary functions Programme Duration (~min) Water Consumption (l) Energy Consumption (kWh) Spin speed (rpm) Prewash Quick Wash Rinse Plus Anti-Creasing Plus water Rinse Hold 90 80 70 60 50 40 30 Cold Temperature Max.
Auxiliary functions Auxiliary Function Selection Buttons C Select the required auxiliary functions before starting the program. C Some combinations cannot be selected together. (Ex.: Pre-wash) (Figure 1-5a) and Quick Wash (Figure 1-5b). Auxiliary function selection If an auxiliary function that should not be selected together with a previously selected function is chosen, the first selected function will be cancelled and the last auxiliary function selection will remain active. (Ex.
5 Maintenance and cleaning brought to the appropriate position, rpm and temperature data reappear. Detergent Drawer Remove any powder residue buildup in the drawer. To do this; 1. Press the dotted point on the siphon in the softener compartment and pull towards you until the compartment is removed from the machine. Switching the machine to standby mode Press “Start/Pause/Cancel” button momentarily to switch your machine to the standby mode.
• Replace the gaskets and filters carefully to their places and tighten the hose nuts by hand. Draining any remaining water and cleaning the pump filter Your product is equipped with a filter system which ensures a cleaner water discharge that extends pump life by preventing solid items such as buttons, coins and fabric fibers from clogging the pump propeller during discharge of the washing water. • If your machine fails to drain the water, the pump filter may be clogged.
6 Solution suggestions for problems Problem Program cannot be started or selected. There is water coming from the bottom of the machine. Machine stopped shortly after the program started. It continuously spins. Remaining time does not count down. It continuously washes. Remaining time does not count down. Cause Explanation / Suggestion Machine may have switched to self protection mode due to Reset your machine by pressing “Start/Pause/ an infrastructure problem (such Cancel” button for 3 seconds.
7 Specifications Models DAW 321 Maximum dry laundry capacity (kg) 8 Height (cm) 84 Width (cm) 60 Depth (cm) 59 Net Weight (kg) 75 Electricity (V/Hz.) 230 V / 50hz Total Current (A) 10 Total Power (W) 2200 Spinning cycle (rpm max.) 1200 Specifications of this appliance may change without notice to improve the quality of the product. Figures in this manual are schematic and may not match your product exactly.
Service Centres If you have followed the instructions and still have a problem, contact the nearest Defy Service Centre. They will be able to advise you on any aspect of the product or send a qualified technician to repair it. BLOEMFONTEIN CAPE TOWN DURBAN EAST LONDON JOHANNESBURG Commercial Head Office, Administration, Distribution, National Groups, Tel. Sales, Contracts and Credit. POLOKWANE PORT ELIZABETH PRETORIA. 160 Long Street, Hilton, Bloemfontein 9301. Tel. 051 400 3900 Bloemfontein.
Warranty. This certificate is issued by DEFY APPLIANCES (PTY) LIMITED, manufacturers and distributors of Defy, Ocean and Franke products, hereinafter the Company, to the original purchaser only, of the appliance described on the certificate and shall constitute the only warranty given in respect of this appliance.
