Owner’s Manual GEMINI MULTI FUNCTION THERMOFAN CONTENTS EYE LEVEL OVEN 2 2 2 2 3 3 4 4 7 10 11 11 11 12 www.defy.co.
INTRODUCTION Congratulations on the purchase of this quality appliance. We, the manufacturer, trust that you will enjoy many years of trouble free use. Please read these instructions carefully before using the oven. This book will provide you with information on how to operate and care for your appliance in order that you gain the maximum benefit from it. UNPACKING • • • Please ensure that packaging material is disposed of in a responsible manner.
INSTALLATION _3 60 + 0 32 Aperture 1085 H x 700 W x 580 D _3 1085 + 0 Aperture +3 700 _ 0 Aperture 32 _3 600 + 0 Typical section showing ventilation requirements Above floor level Floor • • • • Support the oven in front of the aperture and make the electrical connection before installing. This will ensure enough cable length for subsequent servicing. Unscrew and remove the top and bottom trims to expose the fixing holes. Secure the oven to the cabinet using suitable screws.
THE CONTROL PANEL TOP OVEN THERMOSTAT AND INDICATOR LIGHT BOTTOM OVEN MULTIFUNCTION SELECTOR AUTOMATIC OVEN TIMER AND CLOCK MULTI-FUNCTION THERMOSTAT AND INDICATOR LIGHT VARIABLE GRILL S 0 1 8 0 0 1 2 :4 5 1 8 0 1 8 - + GEMINI MULTI - FUNCTION THERM FAN THE OVEN THERMOSTATS ARE MARKED DOWN TO 70°C.
MINUTE MINDER • • • • • • Suppose that you wish to time the boiling of a 5 minute egg. First boil the water Press and hold button 1. The display will show 00.00 Press button 6 until the display shows 00.05 Release the buttons and place the egg in the boiling water. The display will again show the time of day. After 5 minutes the timer will emit an electronic tone which lasts for about one minute (2 beeps every 2 seconds). To cancel the tone, press any of the buttons.
• The word AUTO will flash until button 4 is pressed and manual control is restored. • Return the multi function selector to the OFF position • The oven thermostat must be turned to the OFF position in an anticlockwise direction. Example: Suppose the time of day is now 13h00. The food needs to be cooked for 2 hours at 180°C and it should be ready to serve at 18h00. Here’s what to do. • Ensure the clock is set to the correct time of day, 13.00. • Press buttons 2 and 6 until 02.
MULTI FUNCTION OVEN (BOTTOM OVEN ONLY) The Defy multifunction oven allows a choice of 5 distinctly different cooking modes. 1. 2. 3. 4. 5.
1. FAN ONLY (DEFROSTING) OPERATION • • • Ensure that the timer is set to manual. (Press button 4.) Set the multi function knob to fan only. In this mode the fan at the back of the oven will circulate air at room temperature, substantially reducing the defrosting period required for frozen food placed in the oven. After defrosting is complete, the multi function knob must be turned to 0. 2.
3. CONVENTIONAL BAKE (BOTH OVENS) • • • • • For the bottom oven only, set the timer to manual mode and the multi function knob to normal bake Set the oven thermostat to the required temperature. The indicator light will glow and remain on until the oven has reached the selected temperature. When the indicator light switches off, the food should be placed in the oven.
MAINTENANCE Cleaning the ovens • Switch off the power at the wall switch, open the oven door and allow the oven to cool down. • Remove the oven shelves, side racks, broiler, roast pan, element guard and baking trays. Wash in soapy water, rinse dry and replace. • Clean the oven with a hot soapy cloth. • It may be necessary to soak burnt soils with a liquid cleaner to soften them before scrubbing them with a nylon brush or scouring sponge.
PROBLEM CHECK Before calling a service technician to assist with a problem, PLEASE CHECK THE FOLLOWING 1. The mains distribution board. 2. The wall switch. 3. Set the automatic timer to manual. Push button 4. Remember that you may be charged for a service call even during the warranty period if the fault is due to or caused by any of the above. OWNER’S RESPONSIBILITY Since the following are not factory faults, they are the owner’s responsibility. • Damage to exterior finish.
SERVICE If you have followed the instructions and still have a problem, contact the nearest Defy Service Centre. They will be able to advise you on any aspect of the machine or send a qualified technician to repair it. The Manufacturer strives for continuous improvements. For this reason, the text and illustrations in this book are subject to change without notice.
