User's Manual

Page 5
TOP CHIMNEY DUCT
CEILING MOUNTING BRACKET
DRILL TWO 3.5mm DIA.HOLES
AND INSERT TWO SELF
TAPPING SCREWS
INSERT 4 SELF TAPPING
SCREWS TO ATTACH
THE LOWER CHIMNEY DUCT
TO THE EXTRACTOR
• Remove the plastic outer protective lin-
ing on the grease filter before fitting to
the extractor hood.
• To fit the filter, engage the two lugs at the
rear of the filter into the rectangular slots
of the extractor hood frame, lift the filter
and press the handle catch inwards .
• Engage the filter and release the catch.
• To remove the filter, for cleaning pur-
poses, reverse the procedure described
above.
Grease filter.
• Before fitting the chimneys, connect
the outlet ducting (if required) and in-
sert the fitted plug into the wall socket.
• Remove the protective film from the
chimney ducting taking care not to dam-
age the polished stainless steel surface.
• Fit the upper chimney duct section (the
one with slotted outlets) to the ceiling
mounting bracket using the self tapping
screws supplied.
Optional Carbon pad filter.
• Installations featuring an outside duct do
not require a carbon pad filter.
• Carbon pad filters assist in removing un-
wanted cooking odours from the atmos-
phere.
• Should you require a carbon pad filter, a
factory approved kit may be purchased
from your nearest Defy Service Centre or
their authorised agents.
STEEL ROD REMOVED
STEEL ROD IN PLACE
GREASE FILTER
CARBON PAD FILTER
• The lower duct fits onto the extractor
hood and overlaps the upper duct.
• Loosely attach the lower duct bottom
flange to the hood by four self tapping
screws. The four screw holes are ac-
cessed from the underside of the hood.
• Fit the lower duct to the lower mounting
bracket and tighten the four self tapping
screws on the inside of the extractor
hood.
• Using a 3.5mm dia drill, and using the
two top holes in the lower chimney duct
as a guide, drill through the upper chim-
ney duct.
• Secure both ducts to the centre chimney
mounting bracket using the self tapping
screws supplied.