SDS

blood cells), blood in the urine, or death. Overexposure to a component has been shown to cause damage to the
liver, kidneys, and testis in laboratory animals. Breathing isopropanol vapors has caused damage to the lining of the
middle ear in experimental animal. The relevance of this finding to humans is uncertain. Isopropanol, a component of
this formulation, has been shown to cause harm to the fetus in labortory animal studies. Harm to the fetus occurs
only at exposure levels that harm the pregnant animal. The relevance of these findings to humans is uncertain.
Ethylbenzene, a component of this formulation, has been shown to cause harm to the fetus in labortory animal
studies. Harm to the fetus occurs only at exposure levels that harm the pregnant animal. The relevance of these
findings to humans is uncertain. In animal studies, exposure to a component(s) has been shown to cause damage to
the fetus, only at a level of exposure that would also harm the pregnant animal. The relevance of these findings to
humans is unknown. It also, has been shown to cause neuropathy, mild reversible kidney effects and mild reversible
liver effects in laboratory animals.
Primary Route(s) Of Entry: Skin Contact, Inhalation, Eye Contact
Section 3 - Composition / Information On Ingredients
Component
CAS Number Weight % Reporting Ranges
ACETONE 67-64-1 10-30
2-BUTANONE (MEK) 78-93-3 10-30
PROPANE 74-98-6 10-30
ISOPROPANOL ANHYDROUS 67-63-0 5-10
METHYL ISOBUTYL KETONE 108-10-1 5-10
SOLVENT NAPHTHA, LIGHT ALIPHATIC 64742-89-8 3-7
ETHYL 3-ETHOXYPROPIONATE 763-69-9 1-5
XYLENE 1330-20-7 1-5
NITROCELLULOSE 9004-70-0 1-5
2-BUTOXYETHANOL 111-76-2 1-5
ETHYL BENZENE 100-41-4 0.5-1.5
ALL INGREDIENTS ARE ON THE TSCA INVENTORY LIST, UNLESS OTHERWISE NOTED IN SECTION 8.
Section 4 - First Aid Measures
First Aid - Eye Contact: If material gets into eyes, immediately flush eyes with plenty of water for at least 15
minutes using an eyewash fountain. Lift upper and lower lids and rinse well under them. Get medical attention,
preferably an eye specialist, as needed. If material gets into eyes, flush with water immediately for 20 minutes. Hold
eyelids open to rinse out the entire eye. Consult a physician. If symptoms develop (irritation) from airborne exposure,
move to fresh air.
First Aid - Skin Contact: Remove contaminated clothing and shoes. In case of contact, immediately flush skin
with plenty of water and wash affected areas thoroughly with soap and water for at least 15 minutes. If symptoms
develop (such as irritation or rash), consult a physician or get medical attention. Wash contaminated clothing
thoroughly before reuse or discard.
First Aid - Inhalation: Move to fresh air in case of accidental inhalation of vapors. Give oxygen or artificial
respiration if needed. Asthmatic type symptoms may develop and maybe immediate or delayed by several hours. In
the case of inhalation of aerosol/mist, call 911 immediately.
First Aid - Ingestion: Do not induce vomiting. Do not give anything to an unconscious person. Obtain medical
help.
Section 5 - Fire Fighting Measures
Flash Point (°F): -156 TOC LOWER EXPLOSIVE LIMIT (%):
1.0
UPPER EXPLOSIVE LIMIT (%): 12.
Extinguishing Media: Carbon Dioxide, Dry Chemical, Foam, Water Spray, Dry Sand, Dry Powder
Unusual Fire And Explosion Hazards: Keep containers tightly closed. Isolate from heat, sparks, electrical equipment
and open flame. Fire or intense heat may cause violent rupture of packages. Application to hot surfaces requires
special precautions. Toxic gases may form when product burns. Remove all sources of ignition. Flammable liquid.
Vapors may form an ignitable mixture with air. Vapors are heavier than air and may flow along surfaces, may
travel/spread along the floors/ground, or can be moved by ventilation to a distant ignition source and flashback. Do
not use a cutting or welding torch near or on a drum of product, because vapors may ignite explosively, even if the
drum is empty and contains only product residue. Fire may ensue when product comes in contact with strong
oxidizers. To avoid ignition of vapors by static electricity discharge, all metal parts of the equipment must be
grounded. Peroxides of unknown stability and that are explosive may form. In empty containers, a component's
residue may form vapors that may explode. A component burns with intense heat and rapidly.
Special Firefighting Procedures: In the event of fire, wear self-contained breathing apparatus. Firefighters should
wear full protective clothing. Flammable. Cool fire-exposed containers using water spray. Firefighters should use a
safe distance while fighting the fire.
Section 6 – Accidental Release Measures
Steps To Be Taken If Material Is Released Or Spilled: Evacuate all non-essential personnel. Remove all sources of
Page 2 of 5