Owner's Manual

Figure 11a Figure 11b

• Once you have cut the hole, pull the speaker wire out of the hole and connect the speaker. Strip 1/2” inch (12 mm) of insulation

from each of the two conductors of the wire to expose the bare metal and twist each of the conductors into a single unfrayed strand.

Note that one of the terminals on the rear of each speaker is marked red (+) and the other black (-). Make certain that you connect

the wire from the red terminal (+) of your amplier or receiver to the red terminal (+) on your speaker and the wire from the black

terminal (-) of your amplier or receiver to the black terminal (-) on your speaker. Most wire has some indicator (such as color-coding,

ribbing or writing) on one of the two conductors to help you maintain consistency [Figure 11a]. In the case of the DT 6.5STR single

speaker stereo model, both left and right channel speaker wires are connected to the speaker [Figure 11b].

FIER

CEIVER