Owner's Manual

Figure 6
-
•.....................................
AMPLIFIER
OR
+
r-;;l--+--------t""1t~~~
RECEIVER
Installation Continued
Push down
on
the top of the terminal to reveal the wire
hole in the side of the terminal post
and
insert the wire into
the hole
[Figure
7).
Release
the pressure
on
the terminal to
secure the
wire.
Loosen the rotating lock arms by turning the lock arm
screws
on
the front of the speaker counter clockwise 12 to 1
turn, just enough to allow the lock arm to move
freely.
[Figure
8).
Make
sure that the rotating lock arms are flipped
inwards
[Figure
9)
so
that the speaker fits into the cutout.
Place
the speaker carefully into the cutout.
If
you have a
bubble level, use it to help you correctly align the speaker.
Tighten the lock arm screws with a screwdriver
[Figure
10).
This will rotate the lock arms
[Figure
11)
arid secure the
speaker to the wall/ceiling. Do not over-tighten the lock
arm screws.
If
you are using a powered screwdriver or drill
set the torque to a value of 7 in. -
lb.
(8dN - m).
Install the grille
on
the speaker frame. Powerful magnets
hold the grille in place.
SAFETY
FIRST
When installing your
DI
Series Loudspeakers, be
aware of
the
weight
of
your particular model (see
specification page for
the
weight
of
your model)
and
the sturdiness of the material
into
which you are
installing the speaker. Also be aware
of
any
concealed studs, electrical wiring
or
plumbing in
the
wall
or
ceiling
into
which you are installing
the
speakers.
If
you are
not
sure
of
a safe way
to
install
these speakers, consult a professional installer, your
authorized Definitive Technology dealer, or a building
contractor.
t
Figure 7
o