Owner's Manual
Table Of Contents
Figure 5 Figure 6
6. Once you have cut the hole, fish your previously positioned wiring out
of
the hole and connect your speaker. See the next section for detailed
hookup instructions. Make certain that you connect the wire from the
red terminal ( +)
of
your SubAmp 600 to the red terminal ( +) on your
speaker and the wire from the black terminal (-)
of
your Sub Amp 600
to the black terminal (-)
on
your speaker.
Be
sure to maintain channel
consistency (use either channel one or channel two).
7. Place the subwoofer carefully into the hole
[Figure 5]. Secure the sub
enclosure using the 6 screws provided. These screws go into the holes
in the front
of
the enclosure and angle back into the studs (or,
if
the space
between your studs was wider than 141/2''-151/2'', into the shims).
[Figure
6]
Tighten all the screws
on
one side before installing and tightening the
screws
on
the other side.
8.
Secure the locking arms at the top and bottom
of
the plastic frame
by turning the screws clockwise, taking care not to over tighten.
Making
System
Connections
With
Your
SubAmp
600
Recommended
Hookup
Method
One
1.
Use a Low (Line) Level
RCA
connection from your receiver's LFE Out in
to the
LFE
Input
of
the SubAmp 600.
2. Use Speaker Wire to connect the top set
of
Sub Out Jacks
on
the SubAmp
600 to the terminals
on
the IWSub 10/10.
3.
The
SubAmp
qOO
features an Adjustable Crossover setting on its
front panel. This hookup bypasses the SubAmp 600's Adjustable
Crossover feat\}re.