Owner's Manual

Template
Figure 1
Figure 2
2. Make certain to incorporate at least
11/4"
of
space above and below the area
within the inner wall space to make room for the IWSub's locking arms.
3. With these measurement requirements in mind, place the template against
the inside edge
of
one
of
the studs. (Do not
"center"
the template
if
your
studs are wider than
141/2''-151/2".)
Use
a level to make certain the
template is straight and plumb. The·outside edge
of
the template will
be your exact cutout size.
[Figure
1]
4. Carefully cut the hole with the appropriate cutting tool for your wall mater-
ial. Start the hole by drilling a hole on the inside
of
the template line (with
the drill bit touching the line). Use this hole to insert your saw or knife
and begin cutting.
[Figure
2]
;r·······································
·····
····?l
··
····
···
·
Gaski
strips
i .......... .
···········
·
···········
Figure 3 Figure 4
5. Before installing the speaker in the hole, apply the four long strips
of
gasket material to the speaker: two pieces
on
each side
of
the speaker that
will come into contact with the studs.
[Figure
3]
Use the three shorter strips
of
gasket material to
pad
the rear
of
the speaker against the back
of
the
exposed wall.
[Figure
4]