Owner's Manual
Table Of Contents
Important
Note
Concerning
Your
IWSub
10/10
and
SubAn1p
600
Your IWSub 10/10 is specifically designed to be used in conjunction with
the Definitive Technology SubAmp 600 and should never be used with another
amplifier. You will not achieve optimal performance, and you may cause dam-
age to your IWSub 10/10
if
you attempt to power it using another amplifier
or
receiver. BECAUSE
OF
THIS,
THE
IWSUB 10/10 WARRANTY IS VOIDED
IF
AN
AMPLIFIER
OR
RECEIVER OTHER
THAN
THE
DEFINITIVE
TECHNOLOGY
SUBAMP
600 IS USED TO DRIVE THIS SUB WOOFER.
Installation
Mounting
Your
SubAmp
600
In
An
Audio
Rack
Your SubAmp 600 features side mounting brackets for use in professional audio
racks. When installing the SubAmp 600 in either professional audio racks
or
in
AV
rack furniture, be sure to leave adequate ventilation space around the
SubAmp 600 unit.
0
0
0
-
00
\
I
Definiti~
I
II
0
!\.
I
0
\
Mount1ng Bracket
Mount1ng Bracket
/
Tools Required
for
IWSub
10/10
In-Wall
Installation
• Pencil for marking the location
of
installation.
• Keyhole saw
or
utility knife for cutting drywall.
• Level.
• Screwdriver, preferably powered, with Phillips head bit.
• Power drill with appropriate bit (optional, for starting wall cut).
• Template
(included:
14
3
/s"
x
197/s").
• Gasket material (included).
1.
The IWSub 10/10 is designed to be located between two vertical studs,
inside a space
of
141/2''-151/2",
with the long dimension
of
the speaker
oriented vertically.
If
your studs are spaced wider than this, you will have to
shim one side
of
the inner wall space to properly secure the speaker in a
141/2''-151/2''
space.