Owner's Manual

l
tend to add more "warmth"
to the bass and lower midrange, possibly at the sacri-
fice
of
bass
"tightness"
and midrange clarity. Turning the setting down from the
recommended setting will make the bass and lower midrange sound
"leaner."
Phase
Adjustment
Adjusting the Phase can be a little tricky.
If
you're in doubt, just leave the Phase
at
0
(zero). The best way to adjust the Phase is to get a friend to help you out.
Play music that features a good combination
of
bass notes and deep male vocals
at different frequencies. Have one person sit in the normal listening position
while the other person slowly rotates the Phase control until it reaches the posi-
tion that produces the fullest bass sound across the bass spectrum.
Installing
More
Than
One
IWSub
In
Your
Room,
Or
One
Each
in
Each
of
Tvvo
Rooms
Installing two
IWSub 10/1
Os
into the walls
of
your room,
or
one each in each
of
two rooms, will allow you to achieve a mind-blowing amount
of
bass from sub-
woofers that take up no floor space! The
SubAmp 600 has two separate high
power amplifiers for just this purpose. It is designed to drive one or two
IWSub
10/10s
with full performance and maximum power delivered to each subwoofer.
1.
Connect inputs to the sub as described in Hookup Methods One,
Two
or
Three.
2.
Use Speaker Wire to connect the top set
of
Sub Out Jacks on the
SubAmp
600
to the terminals
on
one
IWSub 10/10.
3.
Use Speaker Wire to connect the bottom set
of
Sub Out Jacks
on
the
SubAmp 600 to the terminals
on
the other
IWSub
10/10.
Multi-Sub Hookup
Sub
1
SubAmp
61111
RCA
from
Receiver
Sub
2