Setup Guide

Safety Precautions
FCC Statement
COMPLIANCE INFORMATION
Product Name: 3.1 Home Theater Sound Bar and Wireless Subwoofer System
Model Number: Studio Slim and Studio Slim Subwoofer
CONTAINS TRANSMITTER MODULE FCC ID: IPUJMDD
FCC ID: IPUSTUDIOSLIM (BAR) FCC ID: IPUSTUSLIMSUB (Subwoofer)
1. This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
2. Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement
1. This transmitter must not be collocated or operating in conjunction with
any other antenna or transmitter.
2. This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your body.
3. FCC RF Warning
This equipment must be installed and operated in accordance with
provided instructions and the antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other
antenna or transmitter. End-users and installers must be provided with
antenna installation instructions and transmitter operating conditions for
satisfying RF exposure compliance.
IC RF Radiation Exposure Statement
CONTAINS TRANSMITTER MODULE IC: 10392A-JMDD
IC: 10392A-STUDIOSLIM (BAR) IC: 10392A-STUSLIMSUB (SUBWOOFER)
This device complies with the Canada portable RF exposure limit set forth
for an uncontrolled environment and are safe for intended operation
as described in this manual. The further RF exposure reduction can be
achieved if the product can be kept as far as possible from the user body or
set the device to lower output power if such function is available.
Canada, Industry Canada (IC) Notices
This Class B digital apparatus complies with Canadian ICES-003. To reduce
potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that permitted for successful communication.
This device complies with Industry Canada license-exempt RSS standard(s).
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device.
For Canadian customers : CAN ICES-3(B) / NMB-3(B)
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the Industry
Canada (IC) radio frequency exposure limits. The Wireless Device should
be used in such a manner such that the potential for human contact during
normal operation is minimized.