Mythos® XTR®-SSA5 Owner’s Manual Manual del usuario Guide d’utilisation
español experience the finest performance possible, we encourage you to take a few moments to fully read this owner’s manual and familiarize yourself with the proper installation and setup procedures for your Mythos XTR speakers. Enjoy. Unpacking your loudspeaker Please unpack your speaker carefully. Please inspect for shipping damage. Any visible damage most likely occurred in handling after it left our plant and should be reported at once.
Contents Índice Table des matières 3 Placement 3 Colocación 3 Position 3 Using L-Bracket Shelf Supports 4 Uso de los soportes en L para estantes 4 Utiliser les équerres 4 5 5 Utiliser les pieds stabilisateurs ajustables 5 Uso de las patas de apoyo de altura regulable Using Adjustable-Height Support Feet Branchement et configuration 6 et 7 Connection & Setup 6&7 Conexión e instalación 6y7 On-Wall Mounting (with bracket) 8&9 Montaje en pared (con soporte) 8y9 Montage mural (avec
Using the L-Bracket Shelf Supports Uso de los soportes en L para estantes Utiliser les équerres When to Use Use these adjustable supports when placing the speaker on a shelf below the TV. They allow you to angle the speaker up towards ear level. english Attach Rubber Pads Remove the two supplied rubber pads from the accessories bag. Peel the paper from the back of the pads exposing the adhesive.
Using the Adjustable-Height Support Feet Uso de las patas de apoyo de altura regulable Utiliser les pieds stabilisateurs ajustables When to Use Use these adjustable feet when placing the speaker on the same shelf as the TV. They allow you to raise the speaker over the TV’s shelf stand. Cuándo utilizarlas Use estas patas regulables cuando coloca la bocina en el mismo estante del televisor. Le permiten elevar la bocina por encima del nivel del estante.
Connection & Setup Conexión e Instalación Branchement et configuration The Mythos XTR wire connection method is different than other speakers. The XTR-SSA5 has a single terminal block connector with one input pair for each channel — Left Front, Right Front, Center, Left Surround and Right Surround. To aid in channel identification, each channel pair is color-coded and color bands are supplied.
+ – FRONT LEFT RIGHT SURROUND RIGHT LEFT CENTER S SURR. BACK/REARR RIGHT RIG LEFT FT If you have a 6.1 or 7.1 channel receiver, connect the SSA’s surround channel inputs to the “Side” or “Side Surround” outputs of your receiver, not the “Rear” or “Surround Back” outputs. Si tiene un receptor de 6.1 o 7.
On-Wall Mounting (with bracket) Montaje en pared (con soporte) Montage mural (avec support) The Mythos XTR loudspeaker was designed to wall-mount near your thin wall-mounted television. A bracket has been supplied to make wall-mounting easier. La bocina Mythos XTR está diseñada para colgarse junto a un televisor montado en la pared. Se incluye un soporte para facilitar el montaje en la pared. english Use the Supplied Template A cardboard mounting template is provided.
*NOTE* Measure Twice Make sure the speaker clears the ceiling, adjacent walls, corners, beams, lighting fixtures and door/window frames. Leave at least 1" (25mm) above or to the side of the speaker location to allow the speaker to slide onto the screws. Make sure the center of the template is centered with the TV screen’s center points.
On-Wall Mounting (without bracket) Montaje en pared (sin soporte) Montage mural (sans support) It is possible to wall-mount an XTR loudspeaker without the supplied bracket. Simply procure the appropriate screws for your installation to carry the speaker weight and follow these steps. Es posible montar una bocina de la serie XTR en la pared sin el soporte provisto. Compre los tornillos adecuados para cargar el peso de la bocina y siga estos pasos.
*NOTE* Measure Twice Make sure the speaker clears the ceiling, adjacent walls, corners, beams, lighting fixtures and door/window frames. Leave at least 1" (25mm) above or to the side of the speaker location to allow the speaker to slide onto the screws. Make sure the center of the template is centered with the TV screen’s center points.
Using a Powered Subwoofer Uso del subwoofer con amplificador Utiliser un caisson des graves actif The Mythos XTR series performs best when complemented with a powered subwoofer. Definitive offers a number of suitable subwoofers to pair with your Mythos XTR loudspeakers. La serie Mythos XTR obtiene su máximo rendimiento cuando se la complementa con un subwoofer con amplificador. Definitive ofrece varios subwoofers que funcionan perfectamente con las bocinas Mythos XTR.
Receiver/Speaker Setup Instalación de las bocinas Configurer le récepteur et les haut-parleurs english DO NOT USE THE “AUTO SETUP” OR “AUDYSSEY®” FEATURE OF YOUR RECEIVER. Because the XTR-SSA5 produces surround sound from a single front-mounted speaker, auto setup features will not operate correctly and may make your system sound worse. 13 Access your receiver’s “Speaker Set-up” or “Speaker Configuration” menu. 1. In the Speaker Set-up/Configure function of your receiver, set all channels to “Small.” 2.
Service Mantenimiento Service et réparation Service and warranty work on your Definitive loudspeaker will normally be performed by the Definitive Technology dealer or importer. If, however, you wish to return the speaker to us, please contact us first, describing the problem and requesting proper authorization. NOTE: Definitive phone and email technical support offered only in English.
Specifications Especificaciones Spécifications Number of Channels Cantidad de canales Nombre de canaux Dimensions Dimensiones Dimensions Driver Complement Bocinas Haut-parleurs 15 5 45"L x 15⁄8"D x 51⁄4"H 114.3 x 4 x 13.2 cm (Alt. x An. x Pr.) 114,3 cm x 4 cm x 13,2 cm (L x P x H) 10 each 31⁄2" (90mm) XTDD dome mid/bass drivers; 3 each 1" (25mm) Pure Aluminum Dome Tweeters 10 bocinas XTDD de medios/graves de 31⁄2" (9cm) y domo cada una; 3 tweeters de domo de aluminio puro de 1” (2.
Warranty 16 Limited Garantía limitada english 5-Years for Drivers and Cabinets, 3-Years for Electronic Components DEI Sales Co.
