Owner's Manual
Table Of Contents
Unpacking
Your
OUR
2300
Please
Insped
For Shipping Damage
Each loudspeaker leaves our plant in perfect condition. Any visible or
concealed damage most likely occurred in handling after it left our plant and
should be reported at once to your Definitive dealer or the delivery company
that delivered your loudspeaker. Please unpack your system carefully. Save
all cartons and packing materials in case you move or need to ship your sys-
tem. Record the serial number found on the back
of
the C/LIR 2300 in the
appropriate place on your warranty card.
Speaker
Break-in
Your
CIlJR
2300s should sound good right out
of
the box; however, an
extended break-in period
of
40-60 hours or more
of
normal playing
is
required
to reach full performance capability. Break-in allows the suspensions to work
in and results
in
fuller bass, a more open "blossoming" midrange and
smoother high frequency reproduction.
Installing
the
Logo
Because the
CIlJR
2300 can be used either vertically or horizontally, the
logo
is
supplied separately. Holes are provided for installation when the speak-
er
is
used horizontally or vertically. These are located under the grill cloth in
recesses that you can feel through the grill cloth at the center
of
the lower long
edge
of
the speaker and at the top and bottom short edge
of
the speaker grill
cloth on the front (so you can orient the speakers with each speaker's woofer
facing in or each speaker's woofer facing out if you position the speakers ver-
tically). Locate the logo over the two holes within each recess that you choose
and gently tap it in through the grill cloth.
Installing
the
Feet/Angling
Device
The CIIJR 2300
is
supplied with brass inserts designed to go into the bottom
of
the speaker, when the speaker
is
positioned horizontally, to hold adjustable
feet which hold the speaker above the surface it
is
placed on as well
as
give you
the option
of
angling the speaker
up
or down
to
point directly at the listeners.
Install three of these inserts
in
the bottom
of
the speakers. There are predrilled
holes on the bottom
of
the speaker under the grill cloth (when the speaker
is
positioned horizontally). Simply locate the holes. Two holes are located a little
back (both the same distance) from the front
of
the speaker. Install brass inserts
in
each
of
these.
You
also have a choice for the rear hole depending on the
depth
of
the surface you will place the speaker
on.
They are located along the
center line going from the front and the back
of
the speaker on the bottom. Then
feel for them and select one
of
these holes. Gently tap the inserts
in
through the
grill cloth and screw the feet
in.