User Guide

BP8060ST &
BP8040ST
One set gets disconnected from the inside of the binding posts. The other end of these
wires stay connected to the internal crossover.
b. Woofer
One set gets disconnected from the circuit board that is mounted to the inside of the
back panel.
i. For serial numbers with the HA code after the 4 digit date code there are
two fast-on connectors
ii. For serial numbers with the HA code after the 4 digit date code there is one
Molex connector
Either way, fast-on or Molex, the other end of these wires stay connected to the woofer.
6. Now that you have marked your crossover and (if applicable) woofer wires, they may be
removed. Needle nose pliers should be used to gently grasp and remove, using as purely lateral
of a motion as possible.
a. Try not to put torsional pressure on the tabs.
b. Be sure to grasp the fast on connector above the male tab sticking up off the board and
below the the wire itself.
c. Aim for the root of the fast on connector where is grabs onto the wire.
d. Remove using as purely lateral a motion as possible.
e. Do not torque the connector
Gasket (if present)
Once you have the amp completely removed use a hammer to gently but firmly tap the staples
securing the gasket back into place.
Wire Harnesses
Be sure to save the wires with the tiny metal jumper clips that snake away into the speaker. It can also
be helpful to use a piece of masking tape to make sure the four wires you disconnected stay easy to find.