Owner's Manual

ZEN-RIO-MAN-15V02 (1009) Copyright © 2015 De ne Instruments
7
4
CONNECTING TO YOUR ZEN-16
4.1 - Expansion terminals (see 2.1S–T)
Connect your ZEN-RIO to
your ZEN-16 using the sup-
plied cable, as shown (right).
The lead should be connect-
ed from the Expansion Out
terminal on the ZEN-16 to
the Expansion In terminal
on the ZEN-RIO.
CAUTION!
Risk of damage to equipment:
Never connect an expansion terminal on a ZEN-16 or
ZEN-RIO to an Ethernet port, network, or any other unap-
proved device.
The ZEN-16 and ZEN-RIO are connected using a standard
Cat5 patch lead, however the expansion terminals are NOT
standard Ethernet ports.
ZEN-RIO
Expansion
In
ZEN-16
Expansion Out
4.2 - So ware setup
So ware setup of the ZEN-RIO is facilitated through our simple and  exible De-
Note that De ne WorkBench does not connect directly to your ZEN-RIO - it connects
to the ZEN-16, and all options relating to the ZEN-RIO are con gured from there.
fi ne WorkBench software, connected to the ZEN-16.