Installation Guide

AA
Hardware Used (Actual Size)
AA
Hardware Used (Actual Size)
AA
I
H
AA
Tap latch flush
5
Install 4 batteries
CAUTION :
Your lock will NOT function properly if this step is not completed. This step will
teach your lock the orientation of your door and is crucial to lock operation.
Test lock with door OPENED to avoid being locked out.
Enter default Master Code( 123456 ).
The detection of the bolt direction takes
10 seconds to complete. Wait until the
Green LED lights up.
See the User Guide for additional information.
NOTE: If Red LED lights up with 3 beeps, refer to
Troubleshooting section or contact
customer service for further assistance.
Step 4: Test Lock
Step 5: Program Lock
Promptly change the Master Code before operating this lockset.
3
Install the latch
4
Install strike plate in door jamb
Insert screws and tighten.
Edge of door
09 10 11
06
OR
You must use the latch that was provided in the packaging.
Edge of door
Set locking and unlocking direction
Wood block (not included)
To unlock
To lock
Enter default Master Code
123456 to unlock.
Press “ ” to lock.
NOTE: Check the strike plate to make sure it is
properly aligned and clear so the bolt can freely
move in the hole.
Tighten the screws evenly.
Insert key and test latch. If latch does not extend or
retract smoothly, adjust Mounting Bolts (CC). Remove key
when finished and make sure the latch bolt is retracted.
CAUTION :
For best performance, use
new, non-rechargeable
Alkaline batteries only.
Ensure correct polarity.
The bulged part of the mounting
plate must face towards the door.
The latch bolt should be
in retracted position.
CC
Slide the cable through the
notch in mounting plate.
Step 3: Install Electronic Deadbolt
08
07
Rotate torque blade to fit in latch.
Cable goes underneath latch.
2
Fasten the mounting plate to door
INSTALLING THE LOCK ASSEMBLIES
1
CC
Hardware Used (Actual Size)
Keep parallel
to door edge.
Do NOT leave the key in the
cylinder during installation.
BB
Hardware Used (Actual Size)
Note : The metal connector
side should face outward.
Connect the cable firmly
into connector port.
The cable must be arranged
as shown in the diagram.
Insert the torque blade into the
interior slot of the thumbturn.
BB
Insert screws and tighten.
CORRECT
WRONG
Keep the thumbturn in
vertical position.
3
Connect the cable firmly into connector port
4
Install interior assembly
A A
AA
AA
AA
TEMPLATE
NOTE: Double check your product for the correct hole sizes.
1-3/4”
(45 mm)
1-3/8”
(35 mm)
1-9/16”
(40 mm)
2”
(51 mm)
Drill a 1” (25 mm) diameter
hole at the center of the door
edge.
Fold here.
Place on the door edge.
2-3/4” (70 mm)
Distance d'entrée
Distance d'entrée
2-3/4” (70 mm)
Backset
Backset
2-3/8” (60 mm)
Ø 1-1/2” (38 mm)
Ø 2-1/8” (54 mm)