Instructions / Assembly

8
Operation (continued)
3
Setting the Sensor for Testing
NOTE: The motion sensor will need to completely warm
up (60 seconds) before beginning the setup process.
□ Turn on power. Conduct a walk test to adjust
the sensor coverage area. Sensor will be in
TEST mode automatically for 2 minutes. Lights
will come on for approximately 2-3 seconds in
TEST mode.
□ Sensor stays in TEST mode until it no longer
senses motion for more than 2 minutes,
then it will revert to the AUTO sensing mode.
□ Turn on the circuit breaker or fuse and the light
switch.
□ Perform a “walk test”. Walk in an arc across the
front of the motion sensor (C).
□ Watch the light. The light will come on indicating
motion has been detected.
□ Stop, wait for the light to turn off, and then begin
walking again.
□ Continue this process until the detection zone
has been established.
□ Adjust the sensor up, down, or side to side to
change the motion sensor (C) detection zone.
HI level security lighting and LO level accent lighting.
4
Adjusting the Motion Sensor
Detection Zone
5
Adjusting the HI/LO Light Level
C
270°
HI-LO feature is off. Works with motion
sensor after dark at 100% brightness.
(Dusk to Dawn Mode): At Dusk, lights will
turn On at 30% of normal brightness and
then will dim to 15% in the middle of the
night hours. The middle of the night is
calculated automatically by the sensor. At
Dawn, lights will turn Off automatically.
(Timer Mode): Seasonally Adjusted Timer:
At Dusk, lights turn On at 30% and then
shut Off in the middle of the night hours
(calculated automatically by the sensor).
HI- LO
2
Sensor Head Adjustment
□ Rotate the motion sensor (C) so the controls
face toward the ground.
□ The sensor can be tilted up and down,
as well as rotated left and right.
C
151209-IQA HD-2703-FA.indd 8 9/12/2015 10:18:36 AM