Instructions / Assembly

7 HOMEDEPOT.com
Please contact 1-866-308-3976 for further assistance.
Installation (continued)
4
Mounting the Light Fixture
□ Plug the connector (BB) into the connector on
the back of the fixture (A).
□ Align the main body (A) to the mounting bracket
screws (GG) and slide the light fixture over the
screws. Firmly push the light fixture against the
junction box, so the mounting bracket screws
come out through the holes on the front of the
light fixture.
□ Attach decorative nuts to the mounting bracket
screws and tighten.
□ Caulk around the edge of the main body (A) and
the mounting surface with silicone sealant
(not included).
□ Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
□ Hinge (1) can tilt the lamps up.
Hinge (2) can pan the lights in and out.
□ Tighten screws (3) if loose.
5
Caulking Around the Light
Fixture
A
Operation
1
Lamp Adjustment
NOTE: Do not rotate the bulb holders more than 180°
from the factory setting.
40º
35º
67º
1
2
1
2
3
3
BB
A
II
II
GG or HH
NOTE: Make sure all the wires are inside the junction box
before attaching the main body (A) to the junction box.
Note: If the mounting bracket screws (GG) are not long enough to allow the decorative nuts (II) to be
threaded on them, then you will need to replace the shorter set of screws (GG) with the longer set of
screws (HH). This is usually due to the junction box being recessed into the wall.
If the longer mounting bracket screws are necessary, remove the fixture from the screws, unplug the
connector wire, remove the mounting bracket and replace the mounting bracket screws with the longer
screws. Repeat the installation steps starting with section 1.
151209-IQA HD-2703-FA.indd 7 9/12/2015 10:18:36 AM