Instructions / Assembly

9 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Operation (continued)
7
Using manual mode
NOTE: Manual mode overrides the motion sensor (C) so
the light will operate full bright. This feature only works
at night and only for one night at a time. The motion
sensor(C) will reset to motion sensing mode after 6 hours
or sunrise, whichever comes rst. Manual mode can be
toggled on and off using a wall switch.
Ƒ Ensure the power to the light is ON and the
sensor has warmed up (60 seconds).
Ƒ To turn manual mode on, switch the power
OFF–ON–OFF–ON at the wall switch within 3
seconds.
Ƒ To turn manual mode off, switch the power
OFF–ON–OFF–ON at the wall switch within 3
seconds.
NOTE: If the power to the light xture is off for more than
5 seconds, allow the motion sensor to warm up prior to
switching to manual mode.
OFF OFFON ON
Less than 3 seconds
Care and Cleaning
Ƒ To prolong the original appearance, clean the light xture with clear water and a soft, damp cloth only.
Ƒ Do not use paints, solvents, or other chemicals on this light xture. They could cause a premature
deterioration of the nish. This is not a defect in the nish and will not be covered by the warranty.
Ƒ Do not spray the light xture with a hose or power washer.
Troubleshooting
Problem Possible Cause Solution
The light will not come on. Ƒ The light switch is turned off. Ƒ Turn the light switch on.
Ƒ The fuse is blown or the circuit breaker
is turned off.
Ƒ Replace the fuse or turn the
circuit breaker on.
Ƒ The light xture is not properly
attached to the mounting plate, if this is
a new installation (the pins are not fully
seated in the terminal block).
Ƒ Re-install the light xture
to the base and ensure the
pins are fully seated in the
terminal block.
Ƒ Daylight turn-off (photocell) is in effect. Ƒ Recheck after dark.
Ƒ The circuit wiring is incorrect (if this is
a new installation).
Ƒ Verify the wiring is correct.
Ƒ The motion sensor is aimed in the
wrong direction.
Ƒ Re-aim the motion sensor
to cover the desired area.
Ƒ The outside air temperature is close to
the same as a person’s body heat.
Ƒ Increase the “SENSITIVITY”
setting.