Instructions / Assembly

7 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Installation (continued)
7
Caulking around the light
fixture
CAUTION: Failure to completely caulk around the light
xture’s mounting plate (D) could result in water seepage
into the light xture (B) and/or junction box.
Ƒ Caulk around the mounting plate (D) and
mounting surface with silicone sealant (not
included).
Operation
1
Adjusting the lamp heads
WARNING: Risk of re. Keep the lamp heads at least
2in. (51mm) from combustible materials.
CAUTION: Keep lamp heads 30° below horizontal to
avoid water damage and electrical shock.
Ƒ Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
Ƒ If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
180°
2
Rotating the sensor controls
downward
CAUTION: To avoid water damage and risk of electrical
shock, the motion sensor controls must be facing the
ground when installation is complete.
Ƒ Rotate the motion sensor (C) so the controls
face toward the ground.
NOTICE: All clearances must be maintained. See Safety Information
on page 2.
MIN MAX
SENSITIVITY
TEST
10S
10MIN
TIME
D
C
A