Instructions / Assembly

9 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Operation
1
Adjusting the lamp heads
□ If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
W
2
Using the OFF control
□ Turn the control dial (E) to the OFF position
to turn the light (B) off and to conserve the
battery life.
W
T
E
S
T
5
S
O
F
F
5
M
i
n
3
Determining the motion sensor
detection zone
NOTE: The motion sensor (C) is non-adjustable. It has a
sensing angle of 180° and a range of approximately 40 ft.
depending on the surrounding temperature.
NOTE: When the control dial (E) is set to the “TEST”
position, the light (B) will operate during the day or night.
The light (B) will stay on for 5 seconds after all motion is
stopped.
NOTE: The motion sensor (C) will need to completely
warm up (60 seconds) before beginning the setup process.
□ Turn the control dial (E) to the TEST position.
□ Perform a “walk test”: walk in an arc across
the front of the motion sensor (C).
□ Watch the light (B). The light (B) will come on
indicating motion has been detected.
□ Stop, wait for the light (B) to turn off, and then
begin walking again.
□ Continue this process until the detection zone
has been established.
W
T
E
S
T
5
S
O
F
F
5
M
i
n
C
B
B
E
E
A