Instructions / Assembly

7 HOMEDEPOT.COM

Please contact 1-866-308-3976 for further assistance.

Installation (continued)

Installing the mounting plate

NOTE: Make sure there is enough vertical space above

the mounting plate to allow the light xture to be mounted.

□ Place the mounting plate (D) against the

mounting surface and ensure the mounting

plate (D) is level. Mark the hole locations.

□ If mounting to a wooden surface, drill two

3/32 in. holes into the mounting surface.

Install the two mounting screws (AA)

through the mounting plate (D) and into

the mounting surface.

□ If mounting to wall board or brick, drill two

7/32 in. holes into the mounting surface.

Insert the wall anchors (BB) and attach the

mounting plate (D) using the two mounting

screws (AA).

Removing the battery cover

□ Press up on the battery compartment cover (3)

locking tab (4) and swing the cover (3) out and

down to remove.

OPEN

PRESS TO CLOSE

OPEN

PRESS TO CLOSE

Connecting the solar battery

This light xture (B) is shipped with the internal,

rechargeable, Li-ion battery disconnected from the

light (B).

□ Gently press down on the wiring harness (5) as

shown by arrow 1.

□ Slide the mail connector into the female

connector as shown in arrow 2.

IMPORTANT: Once the the solar battery harness is connected,

there will be no need to touch this harness again.

Installing the batteries

IMPORTANT: The “C” batteries (6) are used when the rechargeable

solar battery is depleted. When the “C” batteries (6) are depleted,

a red LED (7) will ash inside the motion sensor (C) and the “C”

batteries(6) will need to be replaced.

□ Install three, 1.5V “C” batteries (6 - not

included) into the battery compartment. Make

sure the polarity of the batteries is correct.

□ Replace the battery compartment cover (3).