Instructions / Assembly

6
Installation
1
Determining the mounting
location
NOTE: The light xture should be mounted approximately
8 ft. (2.4 m) above the ground.
NOTE: Ensure the xture and the solar panel are located
close enough together for the cord to reach.
□ Determine the mounting location – wall or eave
mount.
□ Position the lamp head (A) in the general
direction of the desired light coverage.
Wall Mount
E
W
W
Eave Mount
2
Setting the sensor for wall or
eave mounting
□ For wall mounting, turn the ring (1) around
the sensor (C) clockwise until the “W” and the
single indicator is aligned with the mark on the
front of the sensor (C).
□ For eave mounting, turn the ring (1) around the
sensor (C) counterclockwise until the “E” and
the double indicator is aligned with the mark
on the front of the sensor (C).
NOTE: There is a detent at each setting to indicate proper
alignment of the sensor.
W
E
W
Wall Mount Eave Mount
3
Removing the mounting plate
NOTE: This xture comes with a mounting plate (D). It is
pre-assembled on the light xture (B) for shipping.
□ Press the bottom tab (2) of the wall mounting
plate (D) and slide the mounting plate (D) from
the light body (B).
UP
OPEN
PRESS TO CLOSE
A
B
2
1 C
D