Instructions / Assembly
11 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Troubleshooting (continued)
Problem Possible Cause Solution
The lights turn off too late in the
Dusk-to-Dawn setting.
The light xture may be installed in a
relatively dark location.
Relocate the light xture or use
the 3 hour or 6 hour setting.
The lights stay on continuously. Ƒ The motion sensor may be picking up a
heat source, such as an air vent, dryer
vent, or brightly painted, heat-reective
surface.
Ƒ Decrease the “SENS”
setting or reposition the
motion sensor.
Ƒ The motion sensor is in manual mode. Ƒ Switch the motion sensor
to auto. See Using manual
mode on page 9.
Ƒ The light xture is wired through a
dimmer or timer.
Ƒ Do not use a dimmer or
timer to control the light
xture. Replace the dimmer
or timer with a standard on/
off wall switch.
Ƒ The light xture is on the same circuit
as a motor, transformer, or uorescent
bulb.
Ƒ Install the light xture on
a circuit without motors,
transformers, or uorescent
bulbs.
The lights ash on and off. Ƒ Heat or light from the lamp heads may
be turning the motion sensor on and
off.
Ƒ Reposition the lamp heads
away from the motion
sensor.
Ƒ Heat is being reected from other
objects and may be turning the motion
sensor on and off.
Ƒ Decrease the “SENS”
setting or reposition the
motion sensor.
Ƒ The motion sensor is in “TEST” mode
and warming up.
Ƒ While in “TEST” mode,
the light only stays on for
5 seconds. Set the “ON-
TIME” switch to 1, 5, or 20
minutes.
The lights ash once then stay
off in manual mode.
The motion sensor is detecting light from
the lamp heads.
Reposition the lamp heads to
keep the area below the motion
sensor relatively dark.
The Adjustable Color
Temperature dial does not work
in accent (DualBrite) mode.
The Adjustable Color Temperature dial only
works when the light is in full-bright mode.
Adjust the Adjustable Color
Temperature dial when the light
is in full-bright mode.