Instructions / Assembly

8
Operation
1
Adjusting the lamp heads
WARNING: Risk of re. Keep the lamp heads at least
2in. (51mm) from combustible materials.
CAUTION: Keep lamp heads 30° below horizontal to
avoid water damage and electrical shock.
Ƒ Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
Ƒ If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
180°
2
Rotating the sensor controls
downward
CAUTION: To avoid water damage and risk of electrical
shock, the motion sensor controls must be facing the
ground when installation is complete.
Ƒ Rotate the motion sensor (C) so the controls
face toward the ground.
NOTICE: All clearances must be maintained. See Safety Information
on page 2.
1 MIN 5 MIN
TEST 20 MIN
L M H
OFF 3H
DUSK TO DAWN
6H
ON TIME
SENS.
DUAL BRITE
3
Setting the sensor for testing
NOTE: When the “ON-TIME” switch is set to the “TEST”
position, the light xture will operate during the day or
night. The light will stay on for 8 seconds after all motion
is stopped.
Ƒ Set the “ON-TIME” switch to the “TEST”
position.
Ƒ Set the “DUALBRITE” switch to the “OFF”
position.
Ƒ Slide the “SENS” switch to the “L” (low)
position.
NOTE: The motion sensor will need to completely warm
up (60 seconds) before beginning the setup process.
1 MIN 5 MIN
TEST 20 MIN
L M H
OFF 3H
DUSK TO DAWN
6H
ON TIME
SENS.
DUAL BRITE
C
C
A