Instructions / Assembly

Operation (continued)

Using emergency lighting

backup

This light (B) has been designed with a battery backup

system. When the power to the light (B) goes out, the

rechargeable lithium battery (HH) will allow the light

(B) to operate with limited capabilities.

Ƒ The light (B) will work only at night.

Ƒ The light (B) will operate at a reduced light

output of 400 lumens (only the center LEDs (4)

will illuminate).

Ƒ The ON-TIME is set to turn the light (B) off after

10 seconds once all motion has stopped.

Ƒ When the power rst goes out, the light (B) will

come on for 1 minute at night only.

Ƒ When the power is restored, the light (B) will

come on for 1 minute during the day or night.

Using manual mode

NOTE: Manual mode overrides the motion sensor (C) so

the light will operate full bright. This feature only works

at night and only for one night at a time. The motion

sensor(C) will reset to motion sensing mode after 6 hours

or sunrise, whichever comes rst. Manual mode can be

toggled on and off using a wall switch.

Ƒ Ensure the power to the light is ON and the

sensor has warmed up (60 seconds).

Ƒ To turn manual mode on, switch the power

OFF–ON–OFF–ON at the wall switch within 3

seconds.

Ƒ To turn manual mode off, switch the power

OFF–ON–OFF–ON at the wall switch within 3

seconds.

NOTE: If the power to the light xture is off for more than

5 seconds, allow the motion sensor to warm up prior to

switching to manual mode.

OFF OFFON ON

Less than 3 seconds

Care and Cleaning

Ƒ To prolong the original appearance, clean the light xture with clear water and a soft, damp cloth only.

Ƒ Do not use paints, solvents, or other chemicals on this light xture. They could cause a premature

deterioration of the nish. This is not a defect in the nish and will not be covered by the warranty.

Ƒ Do not spray the light xture with a hose or power washer.