Instructions / Assembly

6
Installation (continued)
4
Installing the 1-2- asy
Connect™
□ Connect the ground wire on the mounting
bracket (FF) to the house ground wire using a
wire connector (EE).
□ Route the junction box wires through a hole in
the 1-2- asy Connect™ (D).
□ Place the 1-2- asy Connect™ (D) against the
junction box.
□ When mounting to a wall, the “UP” arrow
must point upward.
□ When mounting to an eave, the “UP” arrow
must point toward the building.
□ Insert the mounting bolt (DD) through the
1-2- asy Connect™ (D) center hole and thread
it into the center hole of the mounting bracket
(FF). Tighten the bolt (DD) securely.
□ Firmly pull on the 1-2- asy Connect™ to verify
it is securely attached to the mounting bracket.
Black
Noir
Negro
L
N
White
Blanc
Blanco
Black
Noir
Negro
L
N
White
Blanc
Blanco
5
Making the electrical
connections
□ Insert the junction box wires into the side of
the terminal block. Tighten terminal block
screws to secure the wires.
□ Insert the white wire from the junction box
into the terminal marked “N (White)”.
□ Insert the black wire from the junction box
into the terminal marked “L (Black)”.
Black
Noir
Negro
L
N
White
Blanc
Blanco
6
Mounting the light fixture
NOTICE: The two pins on the rear of the light xture must be
inserted into the terminal block for the light to work.
□ Align the bottom edge of the light xture (B) with
the bottom edge of the 1-2- asy Connect™
(D). Tilt the light xture (B) toward the 1-2- asy
Connect™ (D), making sure the light xture (B) is
centered on the 1-2- asy Connect™ (D).
□ Tighten the two mounting screws (CC)
securely to the 1-2- asy Connect™ (D). Do not
overtighten.
Black
Noir
Negro
L
N
White
Blanc
Blanco
CC
D
B
D
D
DD
FF
EE